On the front part of the table there is a holding bar which presses the material. Default is a manual mechanism operated by hand, which can be optionally expanded to electromagnetic or pneumatic version.

In the basic version it is operated manually using a handle.

In the electric and pneumatic version, the holding bar lifts with a push of a button, and lowers with its release. These versions also include an option of lifting the holding bar shortly by pressing an additional foot button. This option is helpful in a situation when the unfolded fabric is not situated at the right angle.

The pneumatic version allows lifting the holding bar higher (over 1 cm). It is recommended when working with thicker fabrics, as well as day-night type of roller blinds.

This part must be selected while ordering the cutting table.

Another option to consider is the backlight on the table top. This helps to detect errors and cut off the faulty fragment of the material, saving the rest of fabric. It can vastly affect the material consumption.

This part must be selected while ordering the cutting table.

Guiding strip may be extended with a sliding strip with an angle of 90 degrees or laser extension, which helps to measure the length of the cut. One move of an operator’s hand makes it possible to lock and change the position of the angle strip.

This part can be purchased later.

The adjustable speed of the end cutter is helpful with fabrics that are not easy to cut at high speed. These are mainly synthetic fabrics which tend to stick at high speed. This option allows adjusting the cutting speed between 6000 and 12000 rpm.

This part can be purchased later.

The fabric rolling machine is a simple tool designed for rolling material on the tube. It speeds up preparing a roller blind and helps to keep the material in the right angle. The fabric rolling machine can be operated manually or electrically.

This part can be purchased separately.

Control frame helps to check the correctness of rolling-up the roller shade. The simple chain mechanism or engine allows to coil and unwind the roller shade to check if it is straight. Graspers for the tube are regulated. Width of the test frame can be adjusted, limited only with length of the table top. Control frame can be manual or electric.

This part can be purchased separately.